GOKUL G

 To Prepare MRIR,ITP, Inspection Document, WPS, PQR, WQT & RFI.  To monitor & record welding activities parameters for sour service  inspect Peaking, Banding , Plumbness , Roundness & slope inspection

WORKED WITH: OGC/ORPIC 14”-NGL-PIPELINE (FAHUD TO SOHAR). WORKED WITH: SHAMMER 10”,12” &16”WATER PIPELINE WITH PE LINER  To inspect the Fit up, weld visual, Tie-in & golden joint.  To monitor welding activities & welder performance.  To witness the hydrostatic test , Torquing & Dew point.  To prepare test pack, LHS & submit for client approval before hydrotest. YIBAL KHUFF PROJECT UNDER PDO OMAN & DALEEL PETROLEUM. JOB PROFILE: STORAGE TANK IN CS & SS.  To Prepare MRIR,ITP, Inspection Document, WPS, PQR, WQT & RFI.  To monitor & record welding activities parameters for sour service  To inspect Peaking, Banding , Plumbness , Roundness & slope inspection.  To verify Shell long seam, nozzle orientation marking, fit up for Roof & shell.  To witness vacuum Box Test, RF pad Pneumatic test, Hydrostatic test, Roof pneumatic test & settlement Reading.  To inspect inward material & review MTC submit to client.  To prepare final Test Pack & submit to client  To check Surface preparation, Dft, Holiday Test & Adhesion Test.

WORKED WITH : Sabtank (SABIC Group)  To Prepare Scope of work as per Client Requirements  Arrange pre inspection of Tank (Open Man way, Gas Test & Confined Space Entry). WORKED WITH: CHEVRON PHILIPS JOB PROFILE: AROMAX REACTOR  Preparation and Review of Inspection and Test Plans as per Specification and Client requirements.  To arrange pre Inspection for removing catalyst from reactor.  After removing catalyst from reactor to inspect inside of reactor weld joints.  To inspect elbow wall thickness using ultrasonic thickness gauge & flange face.  To check the outage each level of catalyst.

 Preparation of Inspection and Test Plans as per Specification for Client approval.  Inspect the inward material plate, pipes, tubes, fittings, forgings, valves, gasket, fasteners, etc  Inspect the fabricated material as per drawing & make the dimensional, weld visual report.  To coordinate for Inspection Release Note with Third Party Inspection.

 Check up of MTC’S of all received welding consumables at site ensure that all welding consumables, gases, flux, filler wires meet the code/specification requirement and are in good condition prior to use.  To prepare WPS, PQR&WQT for qualification.  To maintain preheat, interpass & post heating Temperature.  To monitor/observe that all welding related parameters are within the specified limits as stipulated in WPS during welding operation.